Automag III Repairs
Printed From: AMT Guns information
Category: Auto Mag Pistol
Forum Name: Message Board
Forum Description: Message Board
URL: http://www.amtguns.info/forum_posts.asp?TID=26
Printed Date: 27 Mar 2026 at 1:11am
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com
Topic: Automag III Repairs
Posted By: GOTECH LLC
Subject: Automag III Repairs
Date Posted: 16 Mar 2008 at 4:10am
| Aloha, How do I remove the firing pin for inspection and cleaning on a Automag III? Mahalo for your reply. |
Replies:
Posted By: Big Thunder
Date Posted: 16 Mar 2008 at 1:12pm
| I believe you just pull out the safety. |
Posted By: Luc V.
Date Posted: 16 Mar 2008 at 3:54pm
|
Yes the safety lever must be removed to get to the firing pin. Just be carefull not to loose the spring and plunger from the safety lever. Re- install the lever isn't that easy....
|
Posted By: AUTOMAG
Date Posted: 16 Mar 2008 at 4:22pm
|
Luc, I was just looking at my AM lll and noticed that I was missing a grip screw!!! My son had it at the range last and I do not know how I missed it at cleaning. Oh well, I have some spares so I just replaced it. Very fun pistol to shoot and it puts out a very nice light show!!!
------------- "This is the 44 Magnum Auto Mag and holds a 300 grain cartridge and if properly used it can remove the fingerprints"!!! |
Posted By: GOTECH LLC
Date Posted: 16 Mar 2008 at 6:19pm
| Aloha, Thanks! How do you pull out the safety? Drive it out from the right side? Is there i pin or screw to retain the safety? Step by step please. |
Posted By: Luc V.
Date Posted: 16 Mar 2008 at 6:30pm
|
Well it ain't simple to explain in words how to strip this, (and it depends on your handiness) but go to Ians website and find the manual and parts diagram.
This should get you started.
http://www.glossover.co.uk/amt/AutoMagIII/ - http://www.glossover.co.uk/amt/AutoMagIII/
|
Posted By: GOTECH LLC
Date Posted: 16 Mar 2008 at 8:58pm
| Aloha, Thanks Luc V. I had downloaded the manual before. The schematic doesn't show how the parts go together. I figured it out from everyones comments. Kinda easy to do. just need a pin punch. Push the firing pin in to release the safety, slowly slide the safety to the left, blocking the firing pin from flying to neverland with your thumb. Now I can start modifyling the rear sight. Thank you everyone who responded. |
Posted By: Luc V.
Date Posted: 16 Mar 2008 at 9:02pm
|
Good to see you found the way!
It is to long ago since I had took mine apart down to the bones, couldn't tell in a hurry.
 |