AUTOMAG 11 REAR SIGHT REMOVAL
Printed From: AMT Guns information
Category: Auto Mag Pistol
Forum Name: FAQ
Forum Description: They always get asked so take a look first.
URL: http://www.amtguns.info/forum_posts.asp?TID=1464
Printed Date: 27 Mar 2026 at 1:11am
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com
Topic: AUTOMAG 11 REAR SIGHT REMOVAL
Posted By: lyktorct
Subject: AUTOMAG 11 REAR SIGHT REMOVAL
Date Posted: 06 May 2013 at 4:04pm
|
I just purchased a used AMT auto mag 11 and noticed the firing pin does not move smoothly. I assume I have to remove the rear sight in order to access the pin holding the firing pin and spring in place. I removed the roll pin supposedly holding the rear sight in place but it will not separate from the slide. I have some Krol working on the area now. I just don't know if there is any other reason why the rear sight won't separate from the slide. The firing pin will stick in the "fire position" when pressed, not a good thing, I would imagine. Any comments would be appreciated.
|
Replies:
Posted By: wbautomag
Date Posted: 07 May 2013 at 2:32am
|
lyktorct remove the 1/6" pin in the sight and remove the sight level adjusting screw and it should come off.
|
Posted By: lyktorct
Date Posted: 07 May 2013 at 9:27pm
Thank you, that did the trick, BUT, I found a very small, less than 1/8 " wide, C clip underneath it. Any idea where that came from?? I've checked the listing of parts at Numericks and can't find any C clip on the handgun. It is very very thin, but nonetheless, a C clip. I can't imagine it could be part of the rear sight.
|
Posted By: wbautomag
Date Posted: 07 May 2013 at 9:42pm
|
That one I dont know could be a broke rap off of the spring. Are someone could have put it on the screw to kept it from getting lost or something.
|
|